Hi all
I've bought a 3d touch and mounted it 3mm above the nozzel with the pin up. Flashed with Marlin 2.0 by vert.
The probe appears to be working in self test mode but when homing it crashed into the bed.
I'm sure I've mounted it wrong or missed a step somewhere.
Can anyone offer any advice.
I thought I say a good vid for it but all the ones on you tube I can find are a bit rubbish.
Thank you.
3d touch mounting issues.
Re: 3d touch mounting issues.
I've resolved my issue.
I mounted it too high and also had a blob of plastic on my nozzel. Rookie mistake.
I had to alder the z offset which is really nice in marlin 2
I mounted it too high and also had a blob of plastic on my nozzel. Rookie mistake.
I had to alder the z offset which is really nice in marlin 2
Re: 3d touch mounting issues.
That's good. 
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!