White PLA problem (solved, sort of)

Post Reply
countzero
Posts: 12
Joined: Fri Apr 05, 2019 5:12 pm

White PLA problem (solved, sort of)

Post by countzero » Tue May 07, 2019 6:34 pm

Geeetech A10
Marlin 1.1.8

I purchased a spool of white filament from eBay and had to set the flowrate to 500% for it to properly print. Is this normal?

UPDATE:
It turned out the spool was partially deteriorated. A simple test is to bend a bit of filament. If it bends it is okay, but if it is brittle and breaks in half it is not suitable for use.
Last edited by countzero on Sun Jun 09, 2019 7:57 am, edited 1 time in total.
Top
Post Reply

Return to “Geeetech A10 Series”