Dead Geeetech A10 :(

[abssalom]

2 weeks after buy it, i was changing my geeetech a10 nozzle when suddently it stopped working. Control board doesnt seem to power up and i have no idea of what to do there are one red light in control board and one green light in power supply but nothing seems to work.

I was so happy with it and then that...

[abssalom]

No and no. The screen is totally off and the printer doesnt do anything if you connect to the PC. When i powered up before the fan of the control board immediately start to work and the screen lighted up, but now nothing happens except that light.

[abssalom]

Apparently the 10a fuse (which links with the printer itself while the other links only with the hot bed) is dead, I have disassembled the hot end to see what happened and i have realized that the two cables that power up the hot end are quite exposed, when I was changing the nozzle, I had to short-circuit them with the adjustable wrench I use to hold the heather block... Is it normal for those wires to be this exposed?

I have ordered a few 10a fuses to change it and i will try to take care when i change my nozzles.

Regards.

[William]

We will keep an eye on it.

[msi_msi2002]

Dear I had same issue
your power supply volt is very low not 24V
so no fans are working

Check power supply outlet volt
if so ask supplier to replace or buy a new one

[abssalom]

Dear I had same issue
your power supply volt is very low not 24V
so no fans are working

Check power supply outlet volt
if so ask supplier to replace or buy a new one

WUT I dont understand you at all.

I have the stock power supply wich i think is more than enough to power the printer. The problem is that i caused a short-circuit by accident and the 10a fuse broke, that's it. I have replaced it and everyting works prefectly.

Nonetheless I honestly think that Heather Cartridge's wires are quite exposed, a simple touch with my wrench caused this....