Centering

[justdon]

Iam brand new to 3d printing.I just got my geeetech a10 when I printed my first print from the sd card it went flawless now when I slice something from cura and try to print it it always goes to the left hand corner and tries to print there.How do I get it to go back to the center again and print there.

[Mike_27]

is "Origin at center" ticked in the printer settings? If it is, untick it.

[justdon]

Thank you and that did the trick.One more question I tried to print an animal it started fine when it got to the legs it started sliding all over the place do I need to use some sort of adhesive to make it stay in place to print.

[Mike_27]

there are a lot of things which could be wrong;

does the bed wobble when you try to move it from left to right?
does the bed move freely from front to back?
is the Z end stop set correctly?

some of these might help;
https://www.google.com/search?q=ender+3+setup+guide

[justdon]

I guess my best move is to try and check everything.But would it help sometimes if I used the glue stick.