Sticker on speeker
Sticker on speeker
I removed the sticker from the speaker (or beeper) in my A10M and the volume level is much higher. On sticker is label : Remove after washing. Probably the Chinese assembly line operator does not understand it. I've seen many photos here where the sticker has been stuck.
- Attachments
-
- wycinek_GTM32Pro_vB.png (759.71 KiB) Viewed 4546 times
Re: Sticker on speeker
Hello.
This sticker is a testimony to the novelty of the electronic component.
It is often left at the customer's disposal.
This is not a written rule in the world of electronics.
This sticker is a testimony to the novelty of the electronic component.
It is often left at the customer's disposal.
This is not a written rule in the world of electronics.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: Sticker on speeker
Frequency of speaker is changeable using the G-code .... S: frequency in Hz, P: duration in ms. Easy usable in start and stop code, but only without sticker.
Code: Select all
M300 S2500 P100