Share your A10 slic3r/astroprint settings ;-)

WhippingBoy · Post by **WhippingBoy** » Wed Nov 28, 2018 10:18 pm

Im using astroprint.

Does anyone have some good settings for astroprint?
Im quite sure they are using slic3r.

Also I always having a hard time removing the support material. any suggestions for settings here?

Post by **William** » Fri Nov 30, 2018 11:25 am

You can refer to it:

A10-slic3r-config.zip: (1.7 KiB) Downloaded 1134 times

Post by **William** » Fri Nov 30, 2018 11:26 am

Set the support to "Lines,5%"

WhippingBoy · Post by **WhippingBoy** » Mon Dec 03, 2018 10:32 pm

Dear William.

I cant find support lines in the gui?
https://manual.slic3r.org/expert-mode/p ... t-material

Geeetech

Share your A10 slic3r/astroprint settings ;-)

Share your A10 slic3r/astroprint settings ;-)

Re: Share your A10 slic3r/astroprint settings ;-)

Re: Share your A10 slic3r/astroprint settings ;-)

Re: Share your A10 slic3r/astroprint settings ;-)