Geeetech A10 firmware Marlin 1.1.9

[ebam2014]

how do I do this?

[_kaktus_]

Hello.


You need to look carefully at the controller board.
There is a mark on the top and bottom.

In my case it looks like this:

wycinek_GTM32Pro_vB.png (759.71 KiB) Viewed 41982 times

[William]

Hello.


You need to look carefully at the controller board.
There is a mark on the top and bottom.

In my case it looks like this:wycinek_GTM32Pro_vB.png

Good idea of it!

[gdachs]

do all A10s have mega board?

I am not aware of an A10s made by Geeetech. There exists printers named A10s, but they are not made by Geeetech and seemed to be brandless.
So you might be in the wrong forum.

[William]

do all A10s have mega board?

I am not aware of an A10s made by Geeetech. There exists printers named A10s, but they are not made by Geeetech and seemed to be brandless.
So you might be in the wrong forum.

Maybe he means the A10 series printer

[ebam2014]

sorry should I have put A10's????????????? would that have helped!

[gdachs]

sorry should I have put A10's????????????? would that have helped!

Ah, it is the plural of A10, sorry for my message.

Gerald

[ebam2014]

sorry should I have put A10's????????????? would that have helped!

Ah, it is the plural of A10, sorry for my message.

Gerald

lol just a simply misunderstanding...

[T3ste]

Hello,

i have a brannd new A10 with filament detector. My board is a GT2560V3.
Is this firmware for all board revisions?
Can i use a 3D-Touch sensor with this firmware (without to change the source code)?
Is this firmware maintained at github?
Btw: Why i always have to set that the filament sensor in the printer settings to activate it (after every switch on the device)?
Thank you very much!

@Michael: thanks for making and sharing your firmware!

Best regards,
Tino

[ebam2014]

Hello.


You need to look carefully at the controller board.
There is a mark on the top and bottom.

In my case it looks like this:wycinek_GTM32Pro_vB.png

board is the gt2560 rev 6