Hello,
I'm having an issue with my A10M not retracting on one of the filaments. Have not checked if both are having the same issue, but I do recall the other retracting previously. Using the menu to control the motion also fails to retract. I can run it forward as much as I want, but it will not run reverse. Is this likely a firmware issue, a board issue, or a motor issue?
Thanks!
A10M No Retraction Issue
Re: A10M No Retraction Issue
Hello.
This problem may be due to incorrect configuration, or no contacts electrical in the stepstick module socket . And other minor problems.
You have to rule out all possibilities one by one.
This problem may be due to incorrect configuration, or no contacts electrical in the stepstick module socket . And other minor problems.
You have to rule out all possibilities one by one.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.