Home Position

Post Reply
brenthg
Posts: 1
Joined: Thu Mar 17, 2022 9:33 am

Home Position

Post by brenthg » Thu Mar 17, 2022 10:19 pm

I'm new to the 3D Printing world. I have an A10 setup and it prints just fine, but when I HOME the print head, it is about 10mm off the glass bed in both x and y. I have the bed dimensions set to what the factory recommends at x220 y220 with center at 110,110. When I print something it's not in the middle of the bed.

How do I correct this?

BrentHG
Top
Post Reply

Return to “Geeetech A10 Series”