Octoprint and A10T errors

[rems99]

Hello everyone,
I have a problem with octoprint and my A10T since the last update of octoprint.
My extruders are no longer recognized despite a good profile configuration.
I specify that before the update it worked well.
I got the following messages:

Invalid tool reported
Your printer reported tool T0 as invalid, reverting back to T0

Suppressed command
The command T0 was not sent to the printer:

Not queuing T0, that tool doesn't exist according to the printer profile or was reported as invalid by the firmware. Make sure your printer profile is set up correctly.

Thanks for your help.

[Admin]

Octoprint isn't our software, we couldn't handle that problem. But maybe you should try our firmware on website: https://www.geeetech.com/download.html?download_id=49 . and you can try to install the firmware with Cura, like the manual attached.