X and Z axes crashing

Post Reply
Orochimaru
Posts: 4
Joined: Fri Jun 11, 2021 5:40 am

X and Z axes crashing

Post by Orochimaru » Fri Oct 22, 2021 10:38 pm

On my A10M with V4 MB, the X and Z axes are impacting the gantry at the upper limit of their travel (e.g. 220mm X, 260mm Z). Within the last 5mm of travel, the hotend impacts the frame and the motor/belt grinds. Firmware is V1.1.8-V2.0. I've calibrated steps for all axes.
https://speedtest.vet/ https://vidmate.bid/
Any insight or advice would be appreciated.
Top
Post Reply

Return to “Geeetech A10 Series”