When printing a project, my A10T stops to reheat about every 5 minutes. Any help would be appreciated, sorry if this has been asked before.
It does not give an Error message. it just sets there and reheats then starts up again.
I am using CURA 4.91 and printing with color mixing of 3 colors.
A10T keeps stopping to re heat..
Re: A10T keeps stopping to re heat..
Hello, if there is an error, what error is displayed on the screen?
However, the reason for the heating error is likely to be a poor connection. It is recommended that you tie the heating wire of the extruder with a cable tie, and check whether the thermistor and heating wire on the adapter board are loose.
However, the reason for the heating error is likely to be a poor connection. It is recommended that you tie the heating wire of the extruder with a cable tie, and check whether the thermistor and heating wire on the adapter board are loose.