Hello guys I hope someone could maybe help me with setting up the 2208 drivers version 3.0 from bigtreetech I`ve looked all over the place but do not know where to connect the Pdn/UART cables onto the Gt2560 V4.0 Board I got with the Geeetech A-10 printer I`ve tried to contact Geeetech but they just seem to ignore all my questions....
so from my understanding I just have to connect a single cable to the board for each driver I'm planning on using 3 drivers for the x y z axis so 3 cables would need to plug into the gt2560 board but I can`t find any good pinout schematics or just any useful information on where they should be connecting too.
Also i`m using Vert's 2.0 bugfix firmware which works great on the printer with the standard drivers
so before i omegle xender up my board permanently maby someone can help me in the right direction.
TMC 2208 v3.0 on the Gt2560 v4.0 pdn/uart?
-
RileyDylan
- Posts: 3
- Joined: Tue Dec 22, 2020 4:37 pm
TMC 2208 v3.0 on the Gt2560 v4.0 pdn/uart?
Last edited by RileyDylan on Fri Dec 25, 2020 5:06 pm, edited 1 time in total.
-
lindaperryly
- Posts: 3
- Joined: Fri Aug 14, 2020 4:39 pm
Re: TMC 2208 v3.0 on the Gt2560 v4.0 pdn/uart?
And spend another day beside you
Not allowing time to pass standard deviation calculator
Not allowing time to pass standard deviation calculator