I can get this for a good deal right now, sub $300. I don't need to print this large very often, but overall what are the thoughts on this vs what else?
jiofi.local.html
192.168.8.1
router network
Thoughts on the geeetech a10?
Thoughts on the geeetech a10?
Last edited by Sanjay852 on Fri Oct 09, 2020 12:55 am, edited 1 time in total.
Re: Thoughts on the geeetech a10?
Hi! I've bought a10 in the beginning of the may (about 200$), printing with pla is good. PETG so-so, lack of cooling of the hotend radiator.
From the box, as i think, it's better than ender 3. But ender has got numerous fabric aftermarket improvements, with geeetech you could rely only on thingiverse community (
I have replaced loud a4988 drivers to tmc2208, its much more comfortable! On ender you can't do this without board replacement.
Also i'm using marlin 2.0.
Now i'm moving from the stock hotend to the direct e3dv6.
From the box, as i think, it's better than ender 3. But ender has got numerous fabric aftermarket improvements, with geeetech you could rely only on thingiverse community (
I have replaced loud a4988 drivers to tmc2208, its much more comfortable! On ender you can't do this without board replacement.
Also i'm using marlin 2.0.
Now i'm moving from the stock hotend to the direct e3dv6.