FAQ

Post Reply
mahesh123
Posts: 1
Joined: Wed Jul 22, 2020 6:05 pm

FAQ

Post by mahesh123 » Wed Jul 22, 2020 6:09 pm

FAQ For Geeetech A10 series 3d pirnter
Check your PTFE tube plug is deep enough/Smooth.
Refer to this video clean your hotend.
Check the extruder motor direction is correct.
Check the spring of the feeder have enough strength/Too strength of the spring will make the filament broken.
Clean then gear of the feeder.
Top
Post Reply

Return to “Geeetech A10 Series”