Printing with Geeetech Luminous green stringy

[MiloG]

Got a 2week old A10 first time i printed off an Ocotpus from thingiverse full scale it came out ok

Ever since then it now won't print the initial base without webbing up and making a mess eventually causing clumps which catch and pull the base.

I re levelled the base many times still no good. Switched to Geeetech black filament worked absolutely perfect.

I saw on amazon review someone having similar problems and so i used their recommendations of the bed 5 degs warmer and extruder 5 cooler. Slight improvement but still no good with fluro, any help appreciated.

[MiloG]

Is this really the main forums. I can't believe i haven't had a single response or advice, i bought this over Creality thinking support and interest was equal.