Geeetech A10 bltouch help

[viniebenet3]

Finally dipped my toe into the world of 3D printing and have started out with the geeetech A10. I have purchased a bltouch to try and help me along the way.

The problem is I have absolutely no experience of what goes into installing this correctly. I’ve seen loads of videos of people installing the touch itself but I can’t find anything to help me work out what is the right firmware I need and also how and what changes I need to make to the firmware to get it working correctly.

If there is anyone out there who is willing to give some advise or help on how I need to go about installing all of this and what is the correct firmware what changes I need to make and what kind of Gcode profile I need to write to get going I’d be extremely grateful.

[MiloG]

Hi i am looking at doing this myself soon did you look at this guide this seems to be a run through of install and bios on A20M

https://www.youtube.com/watch?v=deq10MaxQBw