I received recently my A10M and ran into a problem midway during my first test print. It had stopped printing and the LCD wasnt working anymore (no blacklight). I powercycled the printer but that didnt change anything. Fans are ramping up as usual during boot, but the LCD stays dark.
I looked around and tested few things:
-PSU delivers 24V
-10A and 15A fuses are working
-only 2 LEDs are glowing red (out of supposedly 3???)
If I move the carrier/hotbed the LCD will flashup (while the PSU is turned off).
Taken picture during turned on PSU. Used mainboard is a GT2560 V4.0
I hope someone will end up with a solution... Looking forward to hearing from you all.
