A new Thermal Runaway A10M?

[MateoAnthony]

I write you from Belgium and I'm a newcomer on your site. There are a lot of informations about printer 3D.

I have the same issue Thermal Runaway on my A10M.
I have my printer since Junuary 2020 and now I have that message. The first time it happened, it was at the end of a 4h print, there was 1cm left. Now it happens anytime. I read the https://speedtest.vet/ https://vidmate.bid/ topics and I measure the hotend thermistor. I found 128K.

I buy a new one but it is bigger than the original but the Ohm is 138K (for the new).

Can someone help me?

Thank you in advance

[William]

Hello, sorry for the late reply,
what specific problem did you encounter?
Can you describe it in detail or provide a video?