SKR V1.3 on the A10 - Any pointers?

[Matsubaa]

It was overkill for just the printer but this is the exact kit I bought: https://www.amazon.com/gp/product/B01MC ... UTF8&psc=1

[axiom]

It was overkill for just the printer but this is the exact kit I bought: https://www.amazon.com/gp/product/B01MC ... UTF8&psc=1

Nice! Thank you!

[t2u]

Hello everybody,
I would like to know if it would be possible to have photos, a diagram, or a detailed explanation of the new connection because I am a little lost with the wiring of the hotend part (extension card).
Thank you in advance for your help.

[William]

Hi，do you mean this?

转接板介绍.png (305.75 KiB) Viewed 24964 times

转接板的3d touch接法.JPG (130.74 KiB) Viewed 24964 times

3d touch 接法.png (398.84 KiB) Viewed 24964 times

[t2u]

yes the extension card in photo.
I would like to know how to connect the extension card to the skr1.3

[t2u]

yes the extension card in photo

[t2u]

Using the below images, I cut the connector off the control-board end of the hotend bundle.

I'm don't have the 3d touch connected yet but I've confirmed I've got motion control, heating and fans.

I've crimped on JST connectors for leads that needed them.
Pin -> Board Connection
6 -> I
7 -> H
8 -> D
9 -> H
10 -> D
11 -> C
12 -> C


it is this part that I do not understand very well, that is why I would have liked more detail on the wiring

[andresdrb]

HI There,

I´m going to do the same mod to my printer (to my A20 actually, but should be the same). COuld someone let me know which jumpers you left where? On this video (https://www.youtube.com/watch?v=GNGN2iSQ5j4&t=866s) they mention to initially remove all jumpers for the drivers and go from there (I know my way around with that) but mentions also other jumpers but I´m not clear which I should leave where. Can you help? I donñt want to burn the board or do something wrong. ANy closeup pictures of the biard wuld help to see which jumper is where.

Cheers

[derekpittx]

I have an SKR 1.3 on the way, arriving Monday since it was actually cheaper to upgrade than to replace. I'll probably step up to the TMC2130's at some later date but for now it's just a straight-up replacement of the GT2560 v3 I'm after.

[Trust35]

Hi! I have installed SKR 1.4. all is ok but i dont't know how connect th eextruder motor In motor is 4 cables black,red,green and blue. How is conneced on SKR? THANK you very much!!