Attaching the super plate to new printer

[William]

Hi William,
could you please define 'pin'. My Super Plate arrived with an adhesive back.

Is the clip.
You can also use double-sided tape.

下载.jpg (19.38 KiB) Viewed 2868 times

[oldtimer2]

Hi, I am getting annoyed with the Super Plate on my new A10M, I level the bed every time i use the printer and then start printing, I send the print job to the printer and it starts normally, after several hours of printing i find the Super Plate dislodged and on the floor, My printer only came with Metal clips which several of them have straightened out and become unusable, I have also tried printing multiple bed clips to hold the Super Plate to the Hot Bed.
When i search online i see other Super Plates that have an peel off back that sticks to the hot bed, My A10M is just a piece of glass. I am getting more and more annoyed with this printer because in the first instance I was sent a machine with the v3.0 board where the item i wanted to purchase was the 800-001-0598 version but i was sent the 800-001-0542. now i waste so much time and material trying to complete a print successfully because of this lack of adhesion between the Super Plate and the HotBed. so annoyed, i feel this printer was a total waste of money and i feel like throwing it into the garbage, so frustrating. what am i doing wrong, obviously there is something missing, this is really driving me mad... can you help me resolve this please

[William]

Hi，you can also use double-sided tape to stick it on the hotbed.