HI all,
i tried to print this owl from thingiverse: https://www.thingiverse.com/thing:18271
it's about 15 cm tall but when the printer were at approx 13 cm it stops extruding so it continues to print movements but with no filament.
what could be the problem in your opinion?
A10M not ends print
Re: A10M not ends print
Hi, You can see if your nozzle is clogged,The nozzle temperature is around 200 and then manually push the consumables,
Check whether the nozzle is discharging.
If it is blocked, clean it up in time.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!