I am new to 3D printing despite the help of a connoisseur and tutorials I can not find a solution ... the brim is not a plate but filaments that stick almost between them.
Then in the rooms we see a lot of holes, the layers are not compact.
I had my printer A10 last Friday, received badly and a lot of play in the paten but she printed the evening. The next day after the adjustments it always makes me the same problem and I seek for 6 days I try different leveling of the bed, different speeds, thicknesses, repetier profile host. please help me (the plateau is not super plan). (sorry for the mistakes it's google translation)
printing problem A10
printing problem A10
- Attachments
-
- imprimante A10 holowing piece.jpg (243.84 KiB) Viewed 3450 times
-
- imprimante A10 brim.jpg (207.06 KiB) Viewed 3450 times
-
- imprimante A10 .jpg (278.29 KiB) Viewed 3450 times
Re: printing problem A10
Hi, You can try to level the hot bed again,
Printing speed reference range: 30-60mm / s
Printing speed reference range: 30-60mm / s
Re: printing problem A10
Bed leveling should do in "hot state". So preheat it for about 15 mins together with extruder adn then do bed leveling.
Calibrate extruder steps
Try it again
Calibrate extruder steps
Try it again
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
Re: printing problem A10
ok thank you very much I would try