Hi，keen.You need to fix the 3d touch on the printer and then adjust it.
Then brush in the firmware with 3d touch.
and like this:https://www.youtube.com/watch?v=_RtsZDbR2po
It's a guide.
I hope this can help you.
install 3D touch how to?
Re: install 3D touch how to?
Hi，keen.You need to fix the 3d touch on the printer and then adjust it.
Then brush in the firmware with 3d touch.
and like this:https://www.youtube.com/watch?v=_RtsZDbR2po
It's a guide.
I hope this can help you.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: install 3D touch how to?
A10/M are good and stable printers and did not need everyday adjustmenst of build plate, if they are correctly tightened and angled. Chinese hands are small and they have small torque, you need to tight all screws by your own. Did not adjust the right side of Z axis of course, it need to be loose.
After first cca 20-30 hours your printer is stabilized and did not need more build plate adjustments. My last adjustments was about 4 months ago after 500km trip in car, assembled of course.
After first cca 20-30 hours your printer is stabilized and did not need more build plate adjustments. My last adjustments was about 4 months ago after 500km trip in car, assembled of course.
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.