Currently I can only print from extruder 0 (the right sided one) but not from extruder 1. I have tried to press the PLA filament out by hand but it seems to be clogged.
I have looked in the manual for advice as well as in this forum and on Youtube, but no success.
How do I remove the clog?
A10M Clogged nozzle
Re: A10M Clogged nozzle
Hi, You can try to manually raise the nozzle temperature to 200°
and then place the consumables to see if any supplies are flowing out of the nozzle to determine if the nozzle is clogged.
If plugged, use a tool to remove the Teflon tube and use a tool to clean the nozzle. Specific operations can refer to this:https://www.youtube.com/watch?v=uKxPIGal74E
I hope this can help you.
and then place the consumables to see if any supplies are flowing out of the nozzle to determine if the nozzle is clogged.
If plugged, use a tool to remove the Teflon tube and use a tool to clean the nozzle. Specific operations can refer to this:https://www.youtube.com/watch?v=uKxPIGal74E
I hope this can help you.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: A10M Clogged nozzle
Hi William
Thank you for your suggestion. It solved my problem, and my printer is now up and running again
Thank you for your suggestion. It solved my problem, and my printer is now up and running again
Re: A10M Clogged nozzle
Thanks for your feedback.-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!