About the three-color color mixing method of Color Mix

[Admin]

About the three-color color mixing method of Color Mix

Hi, guys

something about the three-color mix software

Color mixing software for multi-mixing printer

Scope of application: win7/win8/win10

Supported gcode from:Slic3r, Cura, Easyprint3d and simplify3d. (Other gcode may support, but did not test)


Currently only available for Windows systems



the download link is :https://www.geeetech.com/download.html?download_id=40

and choose this:

(JWBPIBAMJ%DXLA9Z7O{Q~G.png (88.3 KiB) Viewed 34176 times

Note: When the gocde file you loaded is wrong,
There may be a loading error or a software flashback

such as:

GGB`@]0259TDOBM${QPX9T0.png (189.82 KiB) Viewed 34176 times

you can refer to this

ITL$%@E$KWKR_X1~(I%07]H.png (30.31 KiB) Viewed 34176 times

Specific operation method:

TGBM)KM{)Z%TKWN9TMUK4VP.png (34.95 KiB) Viewed 34176 times

wow，enjoy!

[ThomasGee]

Every time I click on "mix color" the programm crashes without errormessage.

tried on twi systems
Win 10 1909 x64

gcode generated with Cury 4.4.0

[William]

Hi, If so, it may be caused by a gcode error,
When you slice it you need to turn off z hop.

[pawien]

turn off z hop ??

[William]

Hi, Extra ups and downs can interfere with the analysis.

[Jarda3d]

I did not use color mixer (done in gcode by hand)...

But Z-hop 0.1mm is very needed for mixing extruder, at least at A10M. Try my actual profile, it was massive updated and you did not need to remove discs in hotend assembly. Sample gcode included for untouched printer (E-steps 340). Try to print the sample on A10T (with 340 Esteps of course).