New Mecreator2 PrusaSlicer issue
Posted: Mon Nov 25, 2019 4:13 am
Hi,
Just fired up my new Mecreator2, if I auto home via the LCD it homes to X175 Y165 and Z0. I set bed size to 160x160 in PrusaSlicer, run a print and the carriage slams into the left (X0) side. I autohomed again and checked the X travel, display reads X175 when homed but will only travel to X20 before slamming into the left rail. I adjusted the bed size to 155x160 and it still slams into the left side at the beginning of the print.
So it seems I do not have the advertised 160x160 print volume. Any assistance would be appreciated thanks.
Just fired up my new Mecreator2, if I auto home via the LCD it homes to X175 Y165 and Z0. I set bed size to 160x160 in PrusaSlicer, run a print and the carriage slams into the left (X0) side. I autohomed again and checked the X travel, display reads X175 when homed but will only travel to X20 before slamming into the left rail. I adjusted the bed size to 155x160 and it still slams into the left side at the beginning of the print.
So it seems I do not have the advertised 160x160 print volume. Any assistance would be appreciated thanks.