Bed is not flat, what are the options?
Posted: Tue Jul 02, 2019 2:11 am
My MeCreator2 is new - arrived yesterday.
When leveling the bed, I noticed that the bed is a bit bulged in the center compared to the corners. There is about 0.5mm raise in the center. I am not sure if this is within the accepted parameters, or the bed requires change.
Just to clarify: MeCreator2 bed is Aluminum with heater PCB.
Thanks.
When leveling the bed, I noticed that the bed is a bit bulged in the center compared to the corners. There is about 0.5mm raise in the center. I am not sure if this is within the accepted parameters, or the bed requires change.
Just to clarify: MeCreator2 bed is Aluminum with heater PCB.
Thanks.