Page 1 of 1
BLTouch???
Posted: Wed Jul 18, 2018 8:05 am
by Benfish65
Hello everyone!
I have the MC2 and it has the GT2560 Rev B control board. Is it possible to add a BLTouch to this printer? Will I have to do anything with the firmware to turn auto leveling on?
Thanks to all who reply!
Re: BLTouch???
Posted: Tue Jul 24, 2018 4:25 pm
by Gingko
It's possible, you can try it.
In their user manual, there might be an introductions of firmware setting.
Re: BLTouch???
Posted: Sun Oct 07, 2018 7:05 am
by Wolle82
Wrong
Re: BLTouch???
Posted: Sun Oct 07, 2018 1:28 pm
by _kaktus_
Wolle82 wrote: ↑Sun Oct 07, 2018 7:05 am
Wrong
Your person can contribute a lot of good to the forum.
But only in one case. When you change your attitude and you will be more helpful to the community.
Would you like to expand on the topic and present your remarks
Re: BLTouch???
Posted: Thu Nov 22, 2018 10:32 pm
by Wolle82
Easy... the orange one is the signal one. As I know red and orange here must be swaped.
Re: BLTouch???
Posted: Fri Nov 23, 2018 12:56 am
by _kaktus_
Re: BLTouch???
Posted: Fri Nov 23, 2018 7:21 pm
by Gingko
Wolle82 wrote: ↑Thu Nov 22, 2018 10:32 pm
Easy... the orange one is the signal one. As I know red and orange here must be swaped.
Yes, you are correct! And sorry, I should double check.
