Z axis too high with 3D Touch!!

Post Reply
tanishbel87
Posts: 8
Joined: Sun Oct 25, 2020 1:15 pm

Z axis too high with 3D Touch!!

Post by tanishbel87 » Thu Dec 09, 2021 4:23 am

Hej,

I just installed the 3D Touch on My I3 Pro W with selve printed mount from instruction, installed the Firmware from this Forum for this and added Code G29 in Cura for My prints. I can see that the Printer is doing the autolevelling, but the result in Z axis is just a few Millimeter too high, therefore the nozzle prints 'in the air' above the bed. What do I Need to adjust here? There is no way to put the 3D Touch sensor higher with this mount.

Thank you in advance for some advice.10.0.0.0.1 192.168.1.254
Top
Post Reply

Return to “Geeetech I3 Pro W”