Geeetech i3 Pro W - Extruder going wrong way
Posted: Fri Oct 01, 2021 4:33 pm
Hi guys,
At a loss on why my extruder is pushing the filament out instead of 'sucking' it in.
Flashed the firmware and set
#DEFINE INVERT_E0_DIR truehttps://9apps.ooo/
#DEFINE INVERT_E0_DIR false
I also set all extruders to true/false
Swapped the plug around
Tried different printing software
Does anyone else have any other ideas?
All of those methods above result in my extruder pushing the filament out.
At a loss on why my extruder is pushing the filament out instead of 'sucking' it in.
Flashed the firmware and set
#DEFINE INVERT_E0_DIR truehttps://9apps.ooo/
#DEFINE INVERT_E0_DIR false
I also set all extruders to true/false
Swapped the plug around
Tried different printing software
Does anyone else have any other ideas?
All of those methods above result in my extruder pushing the filament out.