Geeetech

Okay folks so I have managed to update my firmware after finding a hex version on the geetech website and using cura to update.

My problem is the z axis is moving in the wrong direction and I cannot use arduino/marlin to change the direction (1.0.1) does not work on 64 bit mac osx.

Does anyone know of any solution to this???

TIA

Woo

Hi!
You can try to swap the Z-axis driver with the Y or X-axis driver, and test it again. It may be a driver failure, you can replace the driver.

Hi, you can try these methods:
1)Check the wires of the endstop.
2)You need to check the endstop work or not
http://geeetech.com/forum/viewtopic.php?f=17&t=60927
3)Swap the a4988 driver.This might work