Installing a 3DTouch Auto Leveling Sensor
Posted: Fri Mar 06, 2020 6:33 pm
Hello Guys,
I am new in 3d printing. SO far I am very happy with my Geeetech I3 Pro W. But now i would like to install an auto leveing sensor. Before buying it I read about it and how to install it. I found that you must make some modifications in the frimware. However I found a file called I3 ProW GT2560A+ with 3dtouch.zip This file can be donwloaded here: viewtopic.php?f=10&t=17046
I believe this should be the firmware already modified for auto leveling. However when I compare the modifications that should be done to the firmware as described here: http://www.geeetech.com/wiki/index.php? ... oldid=7914 with the modifications that are done in the downloaded file, I see quiet some differences. So now I wonder what I should do. Should I use the donwloaded file or should I make the modifications as described.
Have you already tried out the firmware I3 ProW GT2560A+ with 3dtouch.zip?
Looking forward for information.
Best
Lucas
I am new in 3d printing. SO far I am very happy with my Geeetech I3 Pro W. But now i would like to install an auto leveing sensor. Before buying it I read about it and how to install it. I found that you must make some modifications in the frimware. However I found a file called I3 ProW GT2560A+ with 3dtouch.zip This file can be donwloaded here: viewtopic.php?f=10&t=17046
I believe this should be the firmware already modified for auto leveling. However when I compare the modifications that should be done to the firmware as described here: http://www.geeetech.com/wiki/index.php? ... oldid=7914 with the modifications that are done in the downloaded file, I see quiet some differences. So now I wonder what I should do. Should I use the donwloaded file or should I make the modifications as described.
Have you already tried out the firmware I3 ProW GT2560A+ with 3dtouch.zip?
Looking forward for information.
Best
Lucas