Geeetech

I have recently received the I3 Pro W as a gift for christmas and have set it up, but when I hooked it up to my computer and tried to print it says it is heating up, but it just stays at room temperature. Also I selected the auto home option on the printer and none of the motors move. I believe everything is plugged in properly. I have tried multiple 3d print softwares. Easy print 3d and Repetier host. I am able to connect to the printer through these programs, but I cannot print, because neither the extruder or the print bed seem to heat up and none of the motors move. I would like to know how I could fix these issues with my printer. I hope this is enough information. Thanks in advance for the help.

Hi,You can see if your wiring is fully connected,

Is the motor wiring on the motherboard correct?

Is it possible to control the printer through the screen and move x / y / z;

Regarding the connection, you can check whether your serial port is correct.

You can try to install the driver manually: https://www.geeetech.com/forum/viewtopi ... RlcFtWdCG4

Thank you for the help, but the printer still has the same problems. I made sure everything was plugged in properly and downloaded the correct driver. The serial port is correct, but the motors do not move on the screen when I try to click on X / Y / Z on the manual controls. Do you know of any other options I could try. Thanks.

Hi, You can check the wiring on the motherboard: