My Z axis coupling is 8mm by 8mm ?!?
Posted: Sun Dec 30, 2018 12:42 pm
The Z axis coupling I received is 8mmX8mm not 8mmX5mm. When it fits onto the stepper motor shaft the coupling has a wobble because it cannot be centered on the shaft with only two set screws 90° opposed. I can make my own spacer or amazon a new one if these won't work well. I haven't got the unit fully assembled but I Don't want to get too far if a wobbly shaft will cause issues down the road.
Also as you can see my fingers are very dirty. Whatever is used to paint the components black needs some reevaluating. I already washed my hands before the picture too. It was everywhere
Also as you can see my fingers are very dirty. Whatever is used to paint the components black needs some reevaluating. I already washed my hands before the picture too. It was everywhere