Page 1 of 1
Very disappointed
Posted: Sun Dec 23, 2018 8:08 pm
by Jimbob
Built my Prussia i3 pro w the power would come on but it wouldn't do any commands and the power supply on the side was making a funny clicking noise then it blew a fuse so how do I go about getting a new power supply
Re: Very disappointed
Posted: Sun Dec 23, 2018 9:18 pm
by _kaktus_
Hello.
If it happened with the load connected, it is a bad sign.
There are two reasons for this:
- Installation error,
- factory defect of the PSU.
It is worth to verify the cause of the defect so that such a situation does not occur again after replacing the PSU.
To replace the power supply with a new working one, please contact your salesperson.
