Very disappointed

[Jimbob]

Built my Prussia i3 pro w the power would come on but it wouldn't do any commands and the power supply on the side was making a funny clicking noise then it blew a fuse so how do I go about getting a new power supply

[_kaktus_]

Hello.


If it happened with the load connected, it is a bad sign.
There are two reasons for this:

• Installation error,
• factory defect of the PSU.

It is worth to verify the cause of the defect so that such a situation does not occur again after replacing the PSU.

To replace the power supply with a new working one, please contact your salesperson.