Page 1 of 1
Nozzle goes up few milimeters when the print starts
Posted: Tue Sep 18, 2018 2:46 pm
by Jesus
Hi,
I've recently purchased a Geeetech I3 pro w. The bed has been leveled correctly but when the print starts the nozzle gets up a few mm and it makes that the filament doesn't adhere to the bed.
Regards,
Re: Nozzle goes up few milimeters when the print starts
Posted: Fri Sep 21, 2018 2:05 pm
by Jesus
Hi,
Fixed, I've just realized that with the T8 threaded rod I needed to send the Gcode "M92 Z400" and "M500".
Regards.
Re: Nozzle goes up few milimeters when the print starts
Posted: Fri Oct 12, 2018 1:35 pm
by wotroc
Hi I have this same problem how do you enter the codes thanks
Re: Nozzle goes up few milimeters when the print starts
Posted: Fri Oct 12, 2018 11:17 pm
by _kaktus_
Hello.
The slicer program you use has a command line.
You can also send commands after connection to a standard console, any program supporting serial communication.
Re: Nozzle goes up few milimeters when the print starts
Posted: Sun Oct 14, 2018 9:37 am
by wotroc
OK I tried entering i think m400 but the z axis went all the way up and it crashed to the top, any chance you could show me how you entered your gcode details I don't really understand how this works thankyou so much for the reply Pete
Re: Nozzle goes up few milimeters when the print starts
Posted: Sun Oct 14, 2018 3:03 pm
by _kaktus_
Hello
Each slicer program in the manual control section has an edit box to send Gcode commands.
