Geeetech

Posted: **Thu Aug 16, 2018 12:32 pm**

Printer is I3 Pro W. If I use Arduino IDE the printer responds fine. For example, if I send G28 g-code to auto home it does it. But in EasyPrint I configure the com port and the printer type. When I click Connect the printer shutters a little and refreshes the LCD display on the printer so I know it's done something, but the Control page doesn't do anything. If you click the Home button, the printer does not home. I tried clicking a few others and they don't do anything either. Below the XY buttons is says "7 Command Waiting". Also, if I select Printer Information page, it says Machine Type is unknown, Firmware and SN are blank.

EasyPrint is version 1.2.0 that I just downloaded from the SourceForge link.

Posted: **Thu Aug 16, 2018 1:17 pm**

Hi

What value have you entered in the baud rate parameter

Posted: **Thu Aug 16, 2018 9:56 pm**

In the Arduino IDE I used 250000. I couldn't find any way to set it in EasyPrint.

Posted: **Fri Aug 17, 2018 10:03 am**

I looked again, more carefully this time.

Anyway, I found it and changed it to 250000 and everything started working. Just finished my first print. Woohoo! Thanks for your help.

Posted: **Fri Aug 17, 2018 2:10 pm**

hey hey axman.

I haven't even managed to help you yet.

Applause for your perceptiveness and for solving the problem by yourself.

Geeetech

Easyprint doesn't talk to the printer

Easyprint doesn't talk to the printer

Re: Easyprint doesn't talk to the printer

Re: Easyprint doesn't talk to the printer

Re: Easyprint doesn't talk to the printer

Re: Easyprint doesn't talk to the printer