Page 1 of 1
cant seem to calibrate my axis on my geeetech pro w
Posted: Tue Jun 12, 2018 1:29 am
by hi-jam
Just finished the build of my geeetech I3 pro W and z axis wont calibrate, plus i was checking the wiring on the board and all looks good but i did hit the reset on the board and now my desplay wont work unless it is plugged into my laptop. Any idea or help would be great.
Re: cant seem to calibrate my axis on my geeetech pro w
Posted: Tue Jun 12, 2018 2:26 pm
by Gingko
Reburn the firmware to have a try.
Re: cant seem to calibrate my axis on my geeetech pro w
Posted: Tue Jun 12, 2018 5:41 pm
by Gingko
Re: cant seem to calibrate my axis on my geeetech pro w
Posted: Wed Jul 11, 2018 7:26 am
by donny
calibrate it like its binding on you or the two motors are not level? use bearing grease on all the rods