Page 1 of 1
Problems with the bed
Posted: Mon May 21, 2018 5:30 pm
by salgarfa
Good moorning, I have some problems with the printer, one of them is the displacement of the bed, as you cas see in the photo. And sometimes the printer stops with the missage error: mintemp.
Re: Problems with the bed
Posted: Mon May 21, 2018 5:58 pm
by Gingko
Dear salgarfa,
seems that the picture didn't upload successfully,
do you have more details?
for mintemp error, you can check this post first:
viewtopic.php?f=23&t=17030
Re: Problems with the bed
Posted: Mon May 21, 2018 6:37 pm
by salgarfa
[attachment=0]P80521-104308.jpg[/attachment]
Re: Problems with the bed
Posted: Mon May 21, 2018 7:20 pm
by Gingko
I think you can check the voltage of the driver(A4988) of Y-axis, I guess it's a little low, increase it to 1.0V to have a try.
Re: Problems with the bed
Posted: Mon Jul 16, 2018 5:34 pm
by salgarfa
Hello, I have return to try with the printer, I have tried to set 1.0V but I can't, the voltage is always 0V or 4,8V. Perhaps I need a new ATmega2560 because mine is damaged.
Re: Problems with the bed
Posted: Mon Jul 16, 2018 5:46 pm
by Gingko
salgarfa wrote: ↑Mon Jul 16, 2018 5:34 pm
Hello, I have return to try with the printer, I have tried to set 1.0V but I can't, the voltage is always 0V or 4,8V. Perhaps I need a new ATmega2560 because mine is damaged.
What about the other drivers? I think is the Y-axis driver broken.