Tightness
Posted: Thu Apr 05, 2018 5:19 pm
Hi,
As a lot of the parts are made of wood I wondered just how tight should these screws, nuts and bolts be?
I suspect it would be very easy to overtighten and damage the wood parts. Can the rods etc be tightened gently with a spanner as I think that my finger tight is not sufficient enough?
I am also a little surprised to see that this question has never been asked before, that I can find anyway.
David
As a lot of the parts are made of wood I wondered just how tight should these screws, nuts and bolts be?
I suspect it would be very easy to overtighten and damage the wood parts. Can the rods etc be tightened gently with a spanner as I think that my finger tight is not sufficient enough?
I am also a little surprised to see that this question has never been asked before, that I can find anyway.
David
