Hello
My I3 proW works great but I would like to change the drivers A4899 for TMC2100 to reduce noise, I do not know if the version of the marlin 2.0 can be configured to change these drivers or if I should try to modify any previous version of the marlin.
I do not know if it is a valid version for the gt2560.
Thanks
marlin 2.0 for I3 proW with TMC2100
Re: marlin 2.0 for I3 proW with TMC2100
Hi, You can replace the driver board with TMC2208
Then change the motor running direction in the firmware.
You can refer to: viewtopic.php?f=17&t=17037
Then change the motor running direction in the firmware.
You can refer to: viewtopic.php?f=17&t=17037
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!