Calibration Error Help Coronavirus

[LoxlyStorm]

Hello,

We are printing FaceMasks for hospitals. I am getting the following disadjustment on them, attach picture.
As am not used to print in my 3D, I do not want to touch if I am not sure it will improve the printing.

Could some one please help me to adjust X Y axis ( I think it is the problem)

Best regards

[William]

Hi, Is your print model too big,
Beyond the print range,
Before printing, you need to level the hot bed.
The distance between the nozzle and the hot bed is a sheet of leveling paper.

[LoxlyStorm]

Dear William,

The model is big but I have no error to be out of range.
Yes, I calibrate with a paper and hot bed is ok, it prints good.
But it seems that X axis and Y axis is not well adjusted because curve is different in each side.
As you can see in the image.
Any idea?

[William]

Hi, you can adjust the belt of the x/y axis.

[LoxlyStorm]

Dear william,

I tight the belt of Y axis and now it works.

Thank you very much!!!

[William]

enjoy print.