Z Axis offset issue

Katsuki · Post by **Katsuki** » Mon Sep 16, 2019 1:10 am

My printer wont save the Z axis offset when calibrating the 3d touch

I have eeprom enables in my config

Katsuki · Post by **Katsuki** » Mon Sep 16, 2019 2:10 am

I've fixed this but completely disabled EEPROM settings and just having a fixed offset in the program, I'll have to change it each time I pull the extruder apart but I guess I would have to the other way also.

There is a note on the guide thread saying to try disabling the EEPROM, this should be made more noticeable, as I skipped it many a times before spotting it to give it a go.

Post by **William** » Mon Sep 16, 2019 9:27 am

Hi, you can use M500 to save.

Geeetech

Z Axis offset issue

Z Axis offset issue

Re: Z Axis offset issue

Re: Z Axis offset issue