Page 1 of 1
Two-color printing configuration
Posted: Thu Mar 22, 2018 4:31 am
by gpau
How do I set up the printer for two-color printing at both the software and hardware level?
I currently use the new firmware for the Geeetech i3 Pro C.
I have not been able to print in two colors yet.
Thank you
Re: Two-color printing configuration
Posted: Thu Mar 22, 2018 6:45 pm
by William
You need to select dual extruder at your printing setting
Re: Two-color printing configuration
Posted: Fri Mar 23, 2018 1:51 am
by gpau
that ok, but what settings should I put
Re: Two-color printing configuration
Posted: Fri Mar 23, 2018 1:54 am
by gpau
this fact, but what settings should I put in the program?
Re: Two-color printing configuration
Posted: Fri Mar 23, 2018 2:17 pm
by William
Re: Two-color printing configuration
Posted: Wed Apr 04, 2018 12:59 am
by gpau
Do you have a repetier-host configuration for the i3 Pro C?
Thank you
Re: Two-color printing configuration
Posted: Wed Apr 04, 2018 8:35 pm
by William
You can refer it
Re: Two-color printing configuration
Posted: Thu Apr 19, 2018 3:33 am
by BR365
I didn't understand, how to configure and calibrate the dual extruder on our I3 C Pro printer, nor how to select, which extruder should be used for which part.
Furthermore, I can't find a possibility, to move the extruder to a specific x-y-coordinate. E.g. I would like to set for Extruder 1, go to x:100, y:100
Then, I do the same for extruder 2 and I would be able to calculate the offset.
Is there a manual or manpage available, to follow step by step?
Thanks,
Moritz