No way to level bed

Mr.Hotwire · Post by **Mr.Hotwire** » Wed Jul 10, 2019 10:58 am

Both upper and lower rods are 7.83mm in diamter, both upper and lower locking rings are tight.

Post by **William** » Wed Jul 10, 2019 11:48 am

Hi, You may need to remove the hot bed and place it in a horizontal position to see if it is uneven.

Mr.Hotwire · Post by **Mr.Hotwire** » Wed Jul 10, 2019 1:16 pm

I have checked that the glass is flat, using a straight edge. And the glass is flat.

Post by **William** » Wed Jul 10, 2019 3:16 pm

Hi, do you have a hotbed under the glass?

Mr.Hotwire · Post by **Mr.Hotwire** » Thu Jul 11, 2019 1:24 am

yes, there is a heated bed under the glass. My machine is a Pro C.

Post by **William** » Thu Jul 11, 2019 9:13 am

Hi, have you checked if the hotbed is level? Remove the inspection on the horizontal plane?

joshi123 · Post by **joshi123** » Sun Sep 20, 2020 2:09 pm

I set an on the right track edge on the glass bed, and the glass bed its self is level. The glass bed is held to the warmth bed by bulldog cuts, insufficient strain to twist the glass. I checked the two sides of the glass just in the event that one side was thicker in the middle then the opposite side.

Geeetech

No way to level bed

Re: No way to level bed

Re: No way to level bed

Re: No way to level bed

Re: No way to level bed

Re: No way to level bed

Re: No way to level bed

Re: No way to level bed