End curse sensor
Posted: Wed Nov 14, 2018 7:52 pm
Greetings,
I share this model for improve the end curse sensor of axys y.
It's designed to: Geeetech prusa I3 A Pro 3D.
I replace the original switch by micro switch. Buy on ebay or remove from your old mouse, it's same.
Sensor model:
After printed and mounted:
Micro switch:
Model:
https://www.thingiverse.com/thing:3214591
Best regards.
I share this model for improve the end curse sensor of axys y.
It's designed to: Geeetech prusa I3 A Pro 3D.
I replace the original switch by micro switch. Buy on ebay or remove from your old mouse, it's same.
Sensor model:
- sensor part.jpg (38.64 KiB) Viewed 14440 times
- sensor on printer.jpg (116.85 KiB) Viewed 14440 times
- micro switch.jpg (14.22 KiB) Viewed 14440 times
Best regards.