Page 1 of 1
Moving Z problem
Posted: Tue Apr 24, 2018 10:33 pm
by Hamed
I just assembled my printer but the z axis move very badly I mean
the torque of motors is very very low and I had to almost open all the screw of the T8 lead screw nut that motors can move the z axis but I know it's not good solution and will reduce the quality of the print so what is the best solution ? is that problem because of the long and slim wires from the drivers to the motors ?
thank you.
Re: Moving Z problem
Posted: Thu Apr 26, 2018 12:26 am
by _kaktus_
A similar problem and ways to solve it are often discussed in the forum.
Just read ...
Re: Moving Z problem
Posted: Sun Apr 29, 2018 9:01 pm
by Hamed
it solved by increasing output current of Z stepper motors driver.
Re: Moving Z problem
Posted: Mon Apr 08, 2019 2:32 am
by Eclipses
Hi, I have exactly same problem could you please help me to understand how to increase the current for the motors? In my printer I did not find any screw for this. Thanks
Re: Moving Z problem
Posted: Mon Apr 08, 2019 12:35 pm
by _kaktus_
Hi.
So you need to read the description of the stepstick module.
Maybe
it?
Re: Moving Z problem
Posted: Mon Nov 15, 2021 1:26 pm
by Gause47
Hamed wrote: ↑Tue Apr 24, 2018 10:33 pm
I just assembled my printer but the z axis move very badly I mean
the torque of motors is very very low and I had to almost open all the screw of the T8 lead screw nut that motors can move the z axis but I know it's not good solution and will reduce the quality of the print so what is the best solution ? is that problem because of the long and slim wires from the drivers to the motors ?
skylightpaycard
thank you.
Z Moves and Mega Evos only work in Ultraspace, there is a config option that ask which World should use old Gen mechanics and youd need to add in 0, for overworld, so that it would work.