Marlin-1.1.8 (05022018) firmware for I3 A pro

[Gingko]

I'm getting this error on arduino software version 1.8.7
U8glib.h: No such file or directory

Put this file in the library and try again,
Sketch->Include Library->Add .ZIP Library.

[_shorty_]

thanks!

[William]

I'm getting this error on arduino software version 1.8.7
U8glib.h: No such file or directory

You need to add the U8gilb on library manager(Arduino).Then it will work.

[flat-jack]

Someone modified the firmware for use with 3D-Touch and get it to work?

[William]

Someone modified the firmware for use with 3D-Touch and get it to work?

You need to check the hardware at first.
If the 3dtouch wires plug correct,the firmware needs to change.
1. Enable the auto level and set the correct value on configuration.h
2.Then you need to set the servo0 pin on board pins.h